We replaced a thermocouple on one of our double-stack ovens that runs 12 hours a day. It's been two months and still very accurate. Went with the OEM version from Market Forge since we’ve had solid luck with their parts before, and this one is no exception. Temperature holds steady and it hasn’t degraded from steam exposure.

This is our third order for pilot burner kits. The others are running great, and this batch is for a new prep kitchen we launched 3 months ago. We maintain multiple facilities and PartsBistro hasn’t failed once. Flame height is controllable, tubing is rigid but bends smoothly. Didn’t go OEM this time. So far so good, the equivalent parts have been reliable and are more budget friendly.

Had irregular gas flow that kept tripping our fryer. Swapped the regulator with this model I bought from PartsBistro and it’s been rock steady. Flame is consistent, no more mid-shift outages. The seal threads were clean and pressure settings locked firm. The part arrived really well-protected, with clear labeling.

I had a quick question before ordering and their support team responded within a short time. The replacement knobs we got are thick, solid, and clearly labeled. You can actually grip them with greasy hands. Not the cheap kind that cracks or spins loose.

Before installing this thermostat on our primary baking oven, the temp was off by 40 degrees. We got the original from Vulcan — pricey, but we prefer them for core components. Now the temperature stays within 5 degrees of the set point consistently. The capillary tube came pre-coiled and tensioned right. I wish we had swapped it out sooner.

Replaced a thermopile on one of our older units. The installation was a breeze and it fired up right away. We’ve had OEM in the past, but this OEM equivalent from PartsBristo is giving the same performance. No complaints from our team.

Had questions, contacted customer service and the response was quick. Installed the new fan blade and motor assembly on an old holding cabinet. The airflow doubled and the humming sound is gone. Bearings run smooth even after several days of full-time use.

After I replaced the old probe on a unit I’ve been tweaking for weeks, this one got the readouts stable immediately. Heat cycles smoothed out, and I didn’t even need to adjust much after the install. I’ve gone through a few of these in different units, and this one gave me the least resistance during setup. Definitely staying on my reorder list.

We tested this gas valve in one of our smaller fryers and it performed exactly to spec. Flow control is precise, no rattles or lag. We’ve even seen consistent results with the same model in low-temp ovens. We have since reordered 10 more from PartsBistro to keep on the shelf for client requests. Can’t risk running out mid-week. Good build. PartsBistro's reliability has really earned our trust.

We were hesitant to buy aftermarket, but this switch panel seems even better than OEM. Clicks cleanly, labels don’t fade under heat, everything from the fit to the wiring felt thoughtfully engineered.